To use Hard Cap Safety Chisels properly, pleae follow the following tips:

• Hard Cap Safety Chisels are used for cutting, shaping and removing metal softer than the cutting edge itself. They may be used to cut cast iron, wrought iron, steel, bronze, copper or to cut rod, wire, nuts, bolts and sheet metal. Do not use on stone or concrete or as a pry bar or wedge.
• A ball peen, engineer’s or nail hammer can be used with a Hard Cap Safety Chisel.
• The diameter of the hammer face should be slightly smaller than the diameter of the Hard Cap. Do not use a hammer that has a mushroomed head or with chips on the face.
• Chisel cutting edge may be redressed to 60° with a file or stone.
• Inspect chisels regularly. Discard any tool that is bent or shows dents, cracks, chips, mushrooming or excessive wear.
• Never use a tool with a deformed cutting edge.
• Warranty applies against defects in material and workmanship under normal use. Exclusive remedy for defects shall be limited to replacement of product without charge.